MASSAPOP PROJETADA

TECHNICAL BULLETIN – MASSAPOP PROJETADA

Click icon to view or download in PDF

Features

MASSAPOP PROJETADA is a product developed to obtain an artistic and decorative finish. Allows painting with water-based acrylic paints. Corrects small imperfections on the walls, making your environment more beautiful and pleasant. Odorless, non-toxic product, with excellent adherence, resistant to alkalinity, giving it excellent durability.

MEETS THE STANDARDS: NBR 13281, NBR 13749.

Usage

MASSAPOP PROJECTADA is indicated for applications on masonry walls and ceilings with straightened plaster. It can be applied in internal and external areas.

Composition

White Cement, selected mineral fillers and special additives.

Color

MASSAPOP PROJETADA is supplied in Ice White.

Yield

Average consumption of 2 kg per m² in the two layers, which may vary according to the porosity of the place to be applied and type of application.

Storage

It must be kept at room temperature, in a dry and ventilated place, on pallets.

Validity

MASSAPOP PROJECTADA is valid for 24 months, inside its original closed packaging.

Packaging

PROJECTED MASSAPOP is supplied in 18 kg plastic packages.

Surface preparation

The surface must be firm and in good condition, free of moisture, dust, grease, mold, mildew, loose particles or any other contamination that could prevent the product from adhering normally. Plasters must be at least 14 days old. Any cracks must be stabilized. If you have a problem with rising damp, you must first waterproof with Selamix. On painted surfaces, deep sanding must be done, removing the paint layer, allowing the product to anchor in the cementitious base.

Product preparation

After calculating the required amount, dilute the product in approximately 22% of water, mixing preferably with a mechanical mixer for 5 minutes, until obtaining a pasty mass without lumps, ideal for application. Once prepared, the product should be applied within a maximum of 1 hour.

For every 18 kg of PROJECTED MASSAPOP add 4 liters of water.

Application

Wet the wall to be applied with a brush or spray gun, etc. Application must be carried out at temperatures between 10 and 30° C. PROJECTED MASSAPOP must be applied in two layers.

First layer: The PROJECTED MASSAPOP must be further diluted and applied with a steel or PVC trowel. The layer must be uniform covering the whole area, avoiding flaws on the surface, with a thickness between 1 and 2 mm. Wait for drying as indicated below.

Second layer: Wait for the first layer to dry until you get a surface resistance to apply the second. This must be applied before the first layer has completely dried. It must be applied with MASSAPOP PROJECTADA diluted in about 22% of water, with a special spray gun, using the nozzle according to the desired appearance. Open the air little by little until you find the ideal mass output volume. Compressor outlet pressure should regulate from 30 to 50 pounds. Hold the gun approximately 40 to 50 cm away from the wall. The projection must evenly cover the entire surface to be applied, taking care not to overload some areas more than others, trying to leave the flakes in equal proportions.

After projecting the mass, wait for it to pre-dry to the point that the flakes no longer adhere to the touch. Make the smoothing with a flat white steel or PVC trowel, in an X shape from one side to the other without splicing the islands, leaving them in similar formats, always with the trowel clean of residues.

Painting

Wait for at least 15 days to dry, use a broom to remove loose particles and start finishing with paint, following the paint manufacturer’s instructions.

Cleaning

Equipment and tools can be cleaned with water while the product is not dry. After drying, clean the tools mechanically.